VENTS - Household fan with increased flow rate VENTS Series X1 Turbo Ф100 - VX1TU-1
Voltage, V / 50Hz: 1*230V
Power, W: 16 W
Flow rate, m3/h: 129 m3/h
Pressure, Pa: 40 Pa
Noise level, dBA 3m: 37 dBA/3m
Protection class, IP: 24 IP
Warranty period, months: 36 months
Fan diameter, mm: 100 mm
Engine Type: Bushing
Axial
APPENDIX
Permanent and or periodic ventilation of bathrooms, kitchens and other service rooms.
Installation in a ventilation shaft or duct.
Sizes compatible with 100, 125 or 150 mm ducts.
DESIGN
Modern design and aesthetic appearance.
The body and fin are made of high quality ABS plastic, UV resistant.
The intelligent blade design gives the fan high efficiency and long life.
Protection class IP 34.
ENGINE
Reliable low wattage motor.
Designed for long-term maintenance-free operation.
Built-in overheating protection.
HAND:
The fan is turned on by the light switch, it is not included in the kit.
The ROPE V key fan is not recommended for ceiling installation.
Fan speed control is possible through a thyristor speed controller. Several fans can be connected to one controller.
AUTOMATICALLY:
Through the electronic control unit BU-1-60. Delivered by separate order.
From the timer T (allows the fan to operate from 2 to 30 minutes after turning off the lights).
Through the humidity sensor and the TN timer (if the humidity in the room rises to the level set by the potentiometer, the fan turns on automatically and continues to work until the normal humidity level. After turning off the humidity sensor, the fan continues to work for the time set by the timer.)
Through the motion sensor and the TP timer (if the motion sensor detects movement, the fan is automatically turned on and continues to work until the time set by the timer from 2 to 30 minutes.)
INSTALLATION
The fan is mounted directly to the ventilation shaft or air duct
Flexible air ducts are recommended in case the ventilation shaft is remote from the installation location. The installation to the air duct is carried out by means of a bracket at the outlet of the fan.
Wall mounting is done using dowels.
Attention!!!
For fans with a timer, humidity sensor and motion sensor, it is necessary to provide an additional permanent phase independent of the light switch.
